INA2321EA/2K5G4 Overview
In the package, you will find a TSSOP-case to contain the op amp ic. The instrumentation amplifier in this picture is of the INSTRUMENTATION AMPLIFIER-type. A Tape and Reel case is used for delivering the op amp. During the past two weeks, there have been close to 14 terminations. A total of 14 pins are located on this board. This linear amplifier should be powered by an 5V battery. The op amp ic has an array of 14 pins on it. Op amp rates 1mV as input offset voltage. You should keep the voltage gain at 60dB for the time being. On the buffer amps, there are 2 channels that can be used. To operate this buffer amplifier, the temperature must not be lower than -55°C. A temperature greater than 125°C should not be used for the operation of buffer amplifier. 6 elements make up the design of this buffer amplifier. The operating supply voltage of the buffer op amp is rated at 5V. This electric component can work from a voltage of under 5.5V as far as supply voltage is concerned. A voltage of 2.7V or higher is recommended for the linear amplifier's supply voltage. The current is quiescent at 40μA. During testing, the instrumentation amplifier resistance should remain within a range of 10 TΩ.
INA2321EA/2K5G4 Features
14 Pins
supply voltage of 5V
60dB voltage gain
Resistance of 10 TΩ
INA2321EA/2K5G4 Applications
There are a lot of Texas Instruments
INA2321EA/2K5G4 Instrumentational OP Amps applications.
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
- Signal filtering
- Signal operation
- Video computer boards
