CY74FCT821ATQCT Overview
In the form of 24-SSOP (0.154, 3.90mm Width), it has been packaged. There is an embedded version in the package Cut Tape (CT). This output is configured with Tri-State, Non-Inverted. It is configured with a trigger that uses a value of Positive Edge. The electronic part is mounted in the way of Surface Mount. The supply voltage is set to 4.75V~5.25V. -40°C~85°C TAis the operating temperature. D-Typeis the type of this D latch. It is a type of FPGA belonging to the 74FCT series. A total of 1elements are present in it. Despite external influences, it consumes 200μAof quiescent current. It has been determined that there have been 24 terminations. Members of the 74FCT821family make up this object. A voltage of 5V is used to power it. The input capacitance of this T flip flop is 5pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. It belongs to the family of electronic devices known as FCT. It is mounted in the way of Surface Mount. There are 24pins on it. This device's clock edge trigger type is Positive Edge. There is a base part number Bus Driver/Transceiverfor the RS flip flops. 10bits are used in its design. In view of its reliability, this D flip flop is a good fit for TAPE AND REEL. An electrical current of 5V volts is applied to it. The D flip flop is embedded with 2ports. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. As a result of its output current of 64mA, it is very flexible in terms of design. It operates with 3 output lines. Currently, there are 10 lines of input.
CY74FCT821ATQCT Features
Cut Tape (CT) package
74FCT series
24 pins
10 Bits
5V power supplies
CY74FCT821ATQCT Applications
There are a lot of Texas Instruments CY74FCT821ATQCT Flip Flops applications.
- CMOS Process
- Bus hold
- Clock pulse
- ATE
- Reduced system switching noise
- Load Control
- Balanced Propagation Delays
- Storage registers
- Event Detectors
- Control circuits
