CY74FCT374TQCT Overview
It is packaged in the way of 20-SSOP (0.154, 3.90mm Width). It is included in the package Cut Tape (CT). It is configured with Tri-State, Non-Invertedas an output. This trigger uses the value Positive Edge. Surface Mountis positioned in the way of this electronic part. A supply voltage of 4.75V~5.25V is required for operation. Temperature is set to -40°C~85°C TA. D-Typedescribes this flip flop. The FPGA belongs to the 74FCT series. A total of 1elements are present in it. T flip flop consumes 200μA quiescent energy. There are 20 terminations,JK flip flop belongs to 74FCT374 family. The power source is powered by 5V. A JK flip flop with a 5pFfarad input capacitance is used here. It is a member of the FCTfamily of D flip flop. In this case, the electronic component is mounted in the way of Surface Mount. A total of 20pins are provided on this board. There is a clock edge trigger type of Positive Edgeon this device. This device has the base part number FF/Latches. It is designed with a number of bits of 8. Its superior flexibility is attributed to its use of 8 circuits. As a result of its reliability, this D flip flop is ideally suited for TR. The D latch operates on 5V volts. The flip flop has 2embedded ports. It is recommended that the supply voltage be kept at 5Vto maximize efficiency. With an output current of 64mA, this device offers maximum design flexibility. There are 3 output lines in this JK flip flop. This frequency can be achieved 250MHz.
CY74FCT374TQCT Features
Cut Tape (CT) package
74FCT series
20 pins
8 Bits
5V power supplies
CY74FCT374TQCT Applications
There are a lot of Texas Instruments CY74FCT374TQCT Flip Flops applications.
- Count Modes
- Single Down Count-Control Line
- Latch-up performance
- Memory
- Consumer
- Storage registers
- Pattern generators
- Computing
- Instrumentation
- Reduced system switching noise
