CD74HCT574QM96EP Overview
It is packaged in the way of 20-SOIC (0.295, 7.50mm Width). It is included in the package Tape & Reel (TR). In the configuration, Tri-State, Non-Invertedis used as the output. It is configured with a trigger that uses Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. The supply voltage is set to 4.5V~5.5V. Temperature is set to -40°C~125°C TA. A flip flop of this type is classified as a D-Type. In FPGA terms, D flip flop is a type of 74HCTseries FPGA. This D flip flop should not have a frequency greater than 60MHz. In total, there are 1 elements. In 20terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. JK flip flop belongs to 74HCT574 family. An input voltage of 5Vpowers the D latch. A JK flip flop with a 10pFfarad input capacitance is used here. Devices in the HCTfamily are electronic devices. Surface Mount mounts this electronic component. 20pins are included in its design. This device has the clock edge trigger type of Positive Edge. This device has the base part number FF/Latches. The flip flop is designed with 8bits. Considering the reliability of this T flip flop, it is well suited for TR. It runs on 5Vvolts of power. The flip flop has 2ports embedded within it. High efficiency requires the supply voltage to be maintained at 5V. The number of input lines is 8. It consumes 8μA of quiescent current without being affected by external factors.
CD74HCT574QM96EP Features
Tape & Reel (TR) package
74HCT series
20 pins
8 Bits
5V power supplies
CD74HCT574QM96EP Applications
There are a lot of Texas Instruments CD74HCT574QM96EP Flip Flops applications.
- Data transfer
- Common Clocks
- Communications
- Storage Registers
- Frequency Divider circuits
- Load Control
- Pattern generators
- Safety Clamp
- Clock pulse
- Control circuits
