5962-0051206Q2A Overview
The instrumentation amplifier in this picture is of the OPERATIONAL AMPLIFIER-type. A Bulk case is used for delivering the op amp. During the past two weeks, there have been close to 20 terminations. A total of 20 pins are located on this board. This linear amplifier should be powered by an 3V battery. This particular linear amplifier is a type of Operational Amplifier device, to be precise. The op amp ic has an array of 20 pins on it. Op amp rates 1.5mV as input offset voltage. You should keep the voltage gain at 109dB for the time being. On the buffer amps, there are 2 channels that can be used. To operate this buffer amplifier, the temperature must not be lower than -55°C. A temperature greater than 125°C should not be used for the operation of buffer amplifier. The linear amplifier is packaged by using a TUBE axis. This electric component can work from a voltage of under 6V as far as supply voltage is concerned. A voltage of 2.7V or higher is recommended for the linear amplifier's supply voltage. This electrical part should be conducted under the dual supply voltage of 3V volts when you conduct this part.
5962-0051206Q2A Features
20 Pins
supply voltage of 3V
109dB voltage gain
5962-0051206Q2A Applications
There are a lot of Texas Instruments
5962-0051206Q2A Instrumentational OP Amps applications.
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
- Signal filtering
- Signal operation
- Video computer boards
