UA741IDT Overview
The linear amplifier is packaged in a 8-SOIC (0.154, 3.90mm Width) case. General Purpose-type instrumentation amplifiers are used in this application. Instrumentation amplifier is delivered in a Cut Tape (CT) case. There is a growing number of terminations approaching the number of 8. A total of 8 pins are located on this board. Please take in mind that op amp should be run at 15V. To be specific, this instrumentation amplifier is a type of Operational Amplifier. 8 pins are located on the operational amplifiers. Op amp rates 5mV as input offset voltage. For this electrical component, the recommended mounting type is Surface Mount, which is the most common. It is recommended that this op amp ic be operated at a temperature no higher than -40°C~105°C for optimal performance. An 1.7mA volt supply current is needed for this linear amplifier to operate. Keeping the voltage gain at 106.02dB is the best course of action. There are 1 elements in this buffer amplifier. The operating supply voltage of instrumentation amplifier is rated 20V voltage. The linear amplifier is packaged by using a TAPE AND REEL axis.
UA741IDT Features
8 Pins
supply voltage of 15V
106.02dB voltage gain
UA741IDT Applications
There are a lot of STMicroelectronics UA741IDT Instrumentational OP Amps applications.
- Signal operation
- Computer workstations
- Oscilloscopes
- single/dual op amp sum and difference circuits
- Comparator
- PDA
- High-frequency data acquisition systems
- Portable docking station
- Proportional counter tubes
- Active probe
