STG5682QTR Overview
The electronic component is convenient to ship overseas because it is packed in a 16-UFQFN. This packaging method provides high reliability because it uses advanced packaging techniques. The multiplexer is located in Surface Mount. 2:1 is the ratio between multiplexers and demultiplexers. Operating temperature around -40°C~85°C TA extended. 16 terminations have been made so far. Due to its 1 channels, the electrical component produces high-quality output. If the voltage supply is 1.8V volts, the electrical component should be turned on and run. A total of 16 pins are injected into the body of the electronic part. Based on SPDT switching circuits, these analog multiplexers work. The multiplexer consists of 2 circuits. Use STG5682 to search for variants of the digital switches. There is 550mOhm internal resistance in this digital multiplexer. For details about the functions of 16 pins, please refer to the datasheets. In this analog multiplexer, the value is Multiplexer or Switches. It is generally not recommended to supply a voltage higher than 4.5V to the switch device in normal circumstances. Single supply type digital switch with a low cost. The lowest voltage the electronic part should receive is 1.65V. For this multiplexer to operate, 50nA current would be sufficient. Using a single voltage supply, this switch device consumes 1.65V~4.5V volts. It may damage the digital multiplexer if the voltage is higher than 50nA. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer.
STG5682QTR Features
1 Channels
Switch Circuit: SPDT
50nA Supply Current
-3db Bandwidth: 33MHz
STG5682QTR Applications
There are a lot of STMicroelectronics STG5682QTR Analog Switches & Multiplexers ICs applications.
- Industrial
- Power routing
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Microwave transmission systems
- FTTH
- Precision test equipment
- Low-Voltage
- Precision data acquisition
- Channel Banks
- E1 Network Equipment
