MC100EL30DW Overview
The item is packaged in 20-SOIC (0.295, 7.50mm Width)cases. D flip flop is embedded in the Tube package. Currently, the output is configured to use Differential. The trigger it is configured with uses Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. A voltage of 4.2V~5.7Vis used as the supply voltage. In the operating environment, the temperature is -40°C~85°C TA. It belongs to the type D-Typeof flip flops. This type of FPGA is a part of the 100EL series. There should be no greater frequency than 1.2GHzon its output. D latch consists of 3 elements. There are 20 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. A voltage of 5V provides power to the D latch. Vsup reaches its maximum value at 5.7V. For normal operation, the supply voltage (Vsup) should be above 4.2V. Additionally, you may refer to the D latch's additional NECL MODE: VCC = 0V WITH VEE = -4.2V TO -5.7V.
MC100EL30DW Features
Tube package
100EL series
MC100EL30DW Applications
There are a lot of Rochester Electronics, LLC MC100EL30DW Flip Flops applications.
- Asynchronous counter
- Set-reset capability
- Safety Clamp
- Divide a clock signal by 2 or 4
- Storage registers
- Matched Rise and Fall
- Data storage
- Power down protection
- Single Up Count-Control Line
- 2 – Bit synchronous counter
