NLAS5213BMUTAG Overview
Due to its 8-UFDFN packaging, the electronic part is convenient for international shipping. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have a ratio of 1:1. Operational temperature extended around -40°C~85°C TA. Total terminations are 8. High-quality output is provided by the electronic component's 2 channels. Powered by a 3.3V voltage supply, the electrical part should be switched on and run. It is part of the design of the 8 series that this electronic component is included. A SPST - NO switching circuit is used to build these analog multiplexers. Try searching for NLAS5213 variants of the analog switch ic. A 1.3Ohm internal resistance characterizes this multiplexer. To find out what the 8 pins do, please refer to the datasheets. The analogue multiplexer in this example is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 4.5V. The digital multiplexer has a low cost Single supply. In order for the electronic part to function properly, the lowest voltage should be 1.65V. It would be sufficient to run this analogue multiplexer with 1μA current. The voltage required by this switch device is 1.65V~4.5V, draining from a single voltage supply. 3V operating voltages are supported by the electronic component. An output of 2 is provided by the digital multiplexer.
NLAS5213BMUTAG Features
2 Channels
Switch Circuit: SPST - NO
1μA Supply Current
-3db Bandwidth: 496MHz
NLAS5213BMUTAG Applications
There are a lot of ON Semiconductor NLAS5213BMUTAG Analog Switches & Multiplexers ICs applications.
- Communication systems
- Video switching
- Automatic test equipment
- Communications systems
- Digital cross connects (DSX-1)
- Battery Powered Systems
- 65 V DACs
- Data switching
- Industrial and process control systems
- Audio and video switching
