MM74HCT574MTC Overview
The flip flop is packaged in a case of 20-TSSOP (0.173, 4.40mm Width). Package Tubeembeds it. T flip flop uses Tri-State, Non-Invertedas the output. It is configured with the trigger Positive Edge. There is an electronic component mounted in the way of Surface Mount. The JK flip flop operates at a voltage of 4.5V~5.5V. It is operating at -40°C~85°C TA. It belongs to the type D-Typeof flip flops. It is a type of FPGA belonging to the 74HCT series. It should not exceed 33MHzin its output frequency. In total, there are 1 elements. T flip flop consumes 8μA quiescent energy. A total of 20terminations have been recorded. JK flip flop belongs to 74HCT574 family. Power is supplied from a voltage of 5V volts. JK flip flop input capacitance is 10pF farads. A device of this type belongs to the family of HCT. Electronic part Surface Mountis mounted in the way. A total of 20pins are provided on this board. It has a clock edge trigger type of Positive Edge. This device has the base part number FF/Latches. The design is based on 8bits. Its flexibility is enhanced by 8 circuits. The power supply is 5V. The flip flop has 2ports embedded within it. For high efficiency, the supply voltage should be set to 5V. To operate, the chip has a total of 3 output lines.
MM74HCT574MTC Features
Tube package
74HCT series
20 pins
8 Bits
5V power supplies
MM74HCT574MTC Applications
There are a lot of ON Semiconductor MM74HCT574MTC Flip Flops applications.
- Data transfer
- Dynamic threshold performance
- Patented noise
- Automotive
- Set-reset capability
- Buffer registers
- Count Modes
- Synchronous counter
- Shift Registers
- Data Synchronizers
