74AC574SJX Overview
20-SOIC (0.209, 5.30mm Width)is the packaging method. It is contained within the Tape & Reel (TR)package. T flip flop is configured with an output of Tri-State, Non-Inverted. The trigger configured with it uses Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. It operates with a supply voltage of 2V~6V. It is operating at -40°C~85°C TA. This electronic flip flop is of type D-Type. JK flip flop belongs to the 74ACseries of FPGAs. Its output frequency should not exceed 153MHz Hz. The list contains 1 elements. As a result, it consumes 40μA quiescent current. The 74AC574 family contains it. A 4.5pFfarad input capacitance is provided by this T flip flop. This electronic part is mounted in the way of Surface Mount. The 20pins are designed into the board. There is a clock edge trigger type of Positive Edgeon this device. The design is based on 8bits. Due to its superior flexibility, it uses 8 circuits. There are no output lines on the JK flip flop. Currently, there are 1 lines of input. -24mA is set as the high level output current. 24mA is the low level output current. A temperature below 85°Cshould be used for operation. A temperature above -40°Cshould be used for the operation. A minimum supply voltage of 2V is required for these RS flip flops to operate. 6Vis the maximum supply voltage it supports. It is possible to obtain a frequency of 153MHz.
74AC574SJX Features
Tape & Reel (TR) package
74AC series
20 pins
8 Bits
74AC574SJX Applications
There are a lot of ON Semiconductor 74AC574SJX Flip Flops applications.
- Frequency division
- Count Modes
- Buffer registers
- Asynchronous counter
- Cold spare funcion
- ATE
- Power down protection
- Parallel data storage
- Single Down Count-Control Line
- QML qualified product
