MC100EL52DR2 Overview
It is embeded in 8-SOIC (0.154, 3.90mm Width) case. A package named Tape & Reel (TR)includes it. T flip flop uses Differentialas its output configuration. It is configured with a trigger that uses Positive, Negative. Surface Mountis in the way of this electric part. A voltage of -4.2V~-5.7Vis used as the supply voltage. A temperature of -40°C~85°C TAis considered to be the operating temperature. A flip flop of this type is classified as a D-Type. This type of FPGA is a part of the 100EL series. There should be no greater frequency than 2.8GHzon its output. It consumes 25mA of quiescent A total of 8 terminations have been made. If you search by 100EL52, you will find similar parts. A voltage of 5V is used as the power supply for this D latch. It is mounted in the way of Surface Mount. The 8pins are designed into the board. A Positive Edgeclock edge trigger is used in this device. The part is included in FF/Latches. There are 1bits in this flip flop. It reaches the maximum supply voltage (Vsup) at 5.7V. A normal operating voltage (Vsup) should remain above 4.2V. Its flexibility is enhanced by 1 circuits. As a result of its reliable performance, this T flip flop is suitable for TAPE AND REEL. It operates from -4.5V power supplies. NECL MODE: VCC = 0V WITH VEE = -4.2V TO -5.7Vis also one of its characteristics. A 50mAvalue is set for the high level output current. There is no low level output current set at 50mA.
MC100EL52DR2 Features
Tape & Reel (TR) package
100EL series
8 pins
1 Bits
-4.5V power supplies
MC100EL52DR2 Applications
There are a lot of ON Semiconductor MC100EL52DR2 Flip Flops applications.
- Data Synchronizers
- Count Modes
- Power down protection
- Control circuits
- Instrumentation
- Buffer registers
- High Performance Logic for test systems
- Digital electronics systems
- Common Clocks
- Divide a clock signal by 2 or 4
