74ACT377SCX Overview
It is embeded in 20-SOIC (0.295, 7.50mm Width) case. D flip flop is embedded in the Tape & Reel (TR) package. Non-Invertedis the output configured for it. The trigger configured with it uses Positive Edge. Surface Mountis occupied by this electronic component. A 4.5V~5.5Vsupply voltage is required for it to operate. A temperature of -40°C~85°C TAis used in the operation. It is an electronic flip flop with the type D-Type. JK flip flop is a part of the 74ACTseries of FPGAs. Its output frequency should not exceed 175MHz Hz. A total of 1elements are contained within it. As a result, it consumes 40μA quiescent current. Members of the 74ACT377family make up this object. There is 4.5pF input capacitance for this T flip flop. This electronic part is mounted in the way of Surface Mount. With its 20pins, it is designed to work with most electronic flip flops. In this device, the clock edge trigger type is Positive Edge. The design is based on 8bits. Its flexibility is enhanced by 8 circuits. For high efficiency, the supply voltage should be set to 5V. The JK flip flop is with 8 output lines to operate. A total of 8input lines have been provided. -24mAis the output current at high level. It is set to 24mAfor the low level output current. If the operating temperature is lower than 85°C, it is recommended. It is recommended that the operating temperature be greater than -40°C. The minimal supply voltage is 4.5V. It is capable of supporting a maximum supply voltage of 5.5V. It is possible to achieve a frequency of 175MHz.
74ACT377SCX Features
Tape & Reel (TR) package
74ACT series
20 pins
8 Bits
74ACT377SCX Applications
There are a lot of ON Semiconductor 74ACT377SCX Flip Flops applications.
- Counters
- 2 – Bit synchronous counter
- Control circuits
- Functionally equivalent to the MC10/100EL29
- Computers
- Digital electronics systems
- ATE
- Memory
- ESD protection
- Test & Measurement
