KA2902DTF Overview
There is a SOP case in which the instrumentation amplifier is packaged. Op amps are OPERATIONAL AMPLIFIER types of amplifier on the chip. Upon delivery, op amp ic is packaged in a Tape & Reel (TR) case. A total of 14 terminations have been reported in the past few weeks. As a reminder, this buffer op amp should be powered by 5V battery and that the battery should be inserted in the amplifier. Instrumentation amplifier is a part of Operational Amplifier. In total, the buffer amplifier consists of 14 pins. In terms of input offset voltage, operational amplifier rates 1.5mV. An 1mA volt supply current is needed for this linear amplifier to operate. It is recommended to keep the voltage gain at 100dB at all times. To operate this buffer amplifier, the temperature must not be lower than -40°C. It is recommended that op amp be used at temperatures below 85°C. 4 elements make up the design of this buffer amplifier. The operating supply voltage of instrumentation amplifier is rated 26V voltage. For the packing of the instrumentation amplifier, TAPE AND REEL is adopted. Under 26V is the minimum supply voltage for this electric component. It is recommended that you keep the instrumentation amplifier's supply voltage higher than 3V when using it. This electrical part should be conducted under the dual supply voltage of 13V volts when you conduct this part.
KA2902DTF Features
supply voltage of 5V
100dB voltage gain
KA2902DTF Applications
There are a lot of ON Semiconductor KA2902DTF Instrumentational OP Amps applications.
- Switching amplifier
- ECG equipment
- Weak signal detection
- Band-pass filter
- Wireless base stations
- Commercial audio systems
- Precision measurement
- Band-stop filter
- Professional videography
- Signal transformation
