FSA4157AP6X Overview
As the electronic part is packed in 6-TSSOP, SC-88, SOT-363, international shipping is convenient. High reliability is achieved by using advanced packaging method Tape & Reel (TR). It is mounted in the position Surface Mount. 2:1 is the number of circuits in the multiplexer and demultiplexer. Temperatures around -40°C~85°C TA are extended for operation. There are 6 terminations totally. A electrical component with 1 channels is capable of high-quality output. When a voltage supply of 4.5V is used, the electronic component should be turned on and run. A SPDT switching circuit is used for these analog switches. Try searching for the analog switch ic with FSA4157 if you are looking for variants. A 1.15Ohm internal resistance characterizes this multiplexer. To find out what the functions of 6 pins are, please refer to their datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. It is generally not recommended to supply a voltage higher than 5.5V to the switch device in normal circumstances. The digital multiplexer has a low cost Single supply. It is recommended to use 2.7V as the lowest voltage for the electrical part. An analogue multiplexer drains from a single voltage supply at 2.7V~5.5V. Putting voltage greater than 500nA on the multiplexer may cause damage. A 300MHz-bandwidth can be used for data transfer. An output of 2 is provided by the digital multiplexer.
FSA4157AP6X Features
1 Channels
Switch Circuit: SPDT
Bandwidth: 300MHz
FSA4157AP6X Applications
There are a lot of ON Semiconductor FSA4157AP6X Analog Switches & Multiplexers ICs applications.
- Cellular phones
- Precision test equipment
- Data switching
- High reliability control systems
- Power routing
- Audio signal routing
- MP3 players
- Access Concentrators
- Channel Banks
- Microprocessor controlled systems
