74AC174SJX Overview
The package is in the form of 16-SOIC (0.209, 5.30mm Width). You can find it in the Tape & Reel (TR)package. Currently, the output is configured to use Non-Inverted. It is configured with a trigger that uses Positive Edge. Surface Mountis in the way of this electric part. The JK flip flop operates with an input voltage of 2V~6V volts. In the operating environment, the temperature is -40°C~85°C TA. There is D-Type type of electronic flip flop associated with this device. It belongs to the 74ACseries of FPGAs. In order for it to function properly, its output frequency should not exceed 125MHz. The element count is 1 . T flip flop consumes 40μA quiescent energy. You can search similar parts based on 74AC174. Its input capacitance is 4.5pFfarads. There is an electronic part that is mounted in the way of Surface Mount. This board is designed with 16pins on it. The clock edge trigger type for this device is Positive Edge. An electronic part designed with 6bits is used in this application. 7 circuits are used to achieve its superior flexibility. In order to operate, the chip has 6 output lines. There are 3 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply. A high level output current of -24mAis set. In the low level output current setting, the current is set to 24mA. Ideally, the operating temperature should be lower than 85°C. Operating temperatures should be above -40°C. It operates with the minimal supply voltage of 2V. 6Vis its maximum supply voltage. It is possible to achieve 125MHz frequencies.
74AC174SJX Features
Tape & Reel (TR) package
74AC series
16 pins
6 Bits
74AC174SJX Applications
There are a lot of ON Semiconductor 74AC174SJX Flip Flops applications.
- Dynamic threshold performance
- Registers
- Power down protection
- Load Control
- Frequency division
- Synchronous counter
- Data storage
- Buffered Clock
- Computers
- Instrumentation
