74AHCT377PW,118 Overview
It is embeded in 20-TSSOP (0.173, 4.40mm Width) case. D flip flop is embedded in the Tape & Reel (TR) package. In the configuration, Non-Invertedis used as the output. This trigger uses the value Positive Edge. This electronic part is mounted in the way of Surface Mount. The supply voltage is set to 4.5V~5.5V. -40°C~125°C TAis the operating temperature. This electronic flip flop is of type D-Type. This type of FPGA is a part of the 74AHCT series. A frequency of 130MHzshould not be exceeded by its output. In total, there are 1 elements. As a result, it consumes 4μA quiescent current and is not affected by external forces. The object belongs to the 74AHCT377 family. This JK flip flop has a 3pFfarad input capacitance. Surface Mount mounts this electronic component. The electronic flip flop is designed with pins 20. In this device, the clock edge trigger type is Positive Edge. Using 1 circuits, it is highly flexible. It is recommended that the supply voltage be kept at 5Vto maximize efficiency. The JK flip flop is with 8 output lines to operate. Currently, there are 8 lines of input. -8mAis the output current at high level. In the low level output current setting, the current is set to 8mA. A temperature below 125°Cis recommended for operation. Ideally, the operating temperature should be higher than -40°C. The minimum voltage required for operation is 4.5V. 5.5Vis the maximum supply voltage supported by it. This can be achieved at a frequency of 130MHz.
74AHCT377PW,118 Features
Tape & Reel (TR) package
74AHCT series
20 pins
74AHCT377PW,118 Applications
There are a lot of Nexperia USA Inc. 74AHCT377PW,118 Flip Flops applications.
- CMOS Process
- Computers
- Memory
- Safety Clamp
- Circuit Design
- Divide a clock signal by 2 or 4
- Single Down Count-Control Line
- Parallel data storage
- Data transfer
- Cold spare funcion
