MAX4748ETE+T Overview
Presented in 16-WQFN Exposed Pad, this electrical component is convenient for overseas shipping. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. There is an analog multiplexer mounted in position Surface Mount. 1:1 is the ratio between multiplexers and demultiplexers. Operational temperature extended around -40°C~85°C TA. 16 terminations have been made so far. A high-quality output is provided by the electrical component's 1 channels. An 3V voltage supply should allow the electrical part to be turned on and run. A key feature of the 16 series is the inclusion of this electronic part as part of its design. A SPST - NC switching circuit is used to build these analog multiplexers. Circuits number 4 make up this analogue multiplexer. Try searching for the analog switch ic with MAX4748 if you are looking for variants. A 50Ohm internal resistance characterizes this multiplexer. To find out what the 16 pins do, please refer to the datasheets. This switch device is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 11V. Analogue multiplexer with a Single supply type that is cost-effective. 2V is the lowest voltage that should be fed to the electronic electronic part. An operating current of 1μA would be sufficient for this switch device. Analogue multiplexers require a 2V~11V voltage to drain from a single voltage supply. There are SEPARATE OUTPUT outputs on this analog switch ic.
MAX4748ETE+T Features
1 Channels
Switch Circuit: SPST - NC
1μA Supply Current
-3db Bandwidth: 250MHz
MAX4748ETE+T Applications
There are a lot of Maxim Integrated MAX4748ETE+T Analog Switches & Multiplexers ICs applications.
- ATM
- PDAs
- Precision data acquisition
- Cable Modem
- Automotive applications
- 65 V DACs
- Medical Instrumentation
- HDTV
- Switching Systems
- Optical Applications
