LT1993IUD-4#PBF Overview
Packaged in a 16-WFQFN Exposed Pad case, the buffer op amp is ready to use. An op amp ic of the Differential type. The op amp is delivered to you in a Tube case. The pins on this board total to 16 in total. I would like to remind you that this buffer op amp should be powered by an 5V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 16 pins are present on the instrumentation amplifier. There is an input offset voltage of 6.5mV for this buffer op amp. The mounting type that is recommended for this electrical part is Surface Mount. In relation to the operating temperature of this buffer op amp, it works well at an average of -40°C~85°C . As long as the supply current of the chip does not exceed 100mA, this op amp ic can operate. 0.827dB should remain the voltage gain. During the manufacturing process, this buffer amplifier is divided into 2 circuits. The linear amplifier consists of 3 different elements in total. Instrumentation amplifier resistance should stay within the range of 3MOhm. A total of 1 instrumentation amplifiers are present on the device.
LT1993IUD-4#PBF Features
16 Pins
supply voltage of 5V
0.827dB voltage gain
Resistance of 3MOhm
LT1993IUD-4#PBF Applications
There are a lot of Linear Technology/Analog Devices
LT1993IUD-4#PBF Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
