BU7264SF-E2 Overview
The linear amplifier is packaged in a SOIC case which makes it easy for the consumer to handle. Buffer amps of this type are called OPERATIONAL AMPLIFIER-types. In the case of Tape & Reel (TR) cases, linear amplifier will be delivered. The number of terminations approaches 14. There are a total of 14 pins on this op amp. As a reminder, this buffer op amp should be powered by 3V battery and that the battery should be inserted in the amplifier. There are two types of Operational Amplifier op amps in this case, and this device falls into one of them. 14 pins are located on the operational amplifiers. Op amp ic rates 1mV for input offset voltage. In order for this instrumentation amplifier to operate, the supply current needs to be between 1.1mA and 10 . On this buffer amplifier, there are 4 circuits. It should not lower than -40°C to operate buffer amplifier. Linear amplifier shouldn't be used above 105°C degrees. TAPE AND REEL is adopted to pack the instrumentation amplifier. It is important to keep in mind that the power supply voltage of this electric component is below 5.5V, which is suitable. This op amp ic is capable of conducting at least 3160 voltage gains.
BU7264SF-E2 Features
14 Pins
supply voltage of 3V
BU7264SF-E2 Applications
There are a lot of ROHM Semiconductor BU7264SF-E2 Instrumentational OP Amps applications.
- Video amplifiers
- Division circuits
- Signal amplification
- Power control
- PDA
- Automotive sensors
- Tablets
- Navigation
- Inverse/same-phase proportional circuit
- Biopotential
