PA08 Overview
Packaged in a TO-3 case, the buffer op amp is ready to use. An op amp ic of the OPERATIONAL AMPLIFIER type. There is a growing number of terminations approaching the number of 8. The pins on this board total to 2 in total. I would like to remind you that this buffer op amp should be powered by an 100V battery. A total of 8 pins are present on the instrumentation amplifier. There is an input offset voltage of 500μV for this buffer op amp. As long as the supply current of the chip does not exceed 6mA, this op amp ic can operate. 118dB should remain the voltage gain. During the manufacturing process, this buffer amplifier is divided into 1 circuits. For the buffer op amp to operate properly, it must be above the temperature of -25°C degrees Celsius. No temperature greater than 85°C should be used. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 150V volts.
PA08 Features
2 Pins
supply voltage of 100V
118dB voltage gain
PA08 Applications
There are a lot of Cirrus Logic
PA08 Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
