MAX4381EUB+T Overview
There is a 10-TFSOP, 10-MSOP (0.118, 3.00mm Width) case in which the instrumentation amplifier is packaged. The instrumentation amplifier in this picture is of the Voltage Feedback-type. Upon delivery, op amp ic is packaged in a Tape & Reel (TR) case. It is estimated that there will be 10 terminations in the next few months. A total of 10 pins are attached to buffer op amp. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. In more specific terms, this linear amplifier can be categoriOperational Amplifiered as a Operational Amplifier-type device. For this electronic part, it is recommended that you mount it with type Surface Mount. With regard to operating temperature, op amp ranges -40°C~85°C. On this instrumentation amplifier, there are 2 circuits that are connected together. There are more than a few advantages to using this instrumentation amplifier, one of which is that it outputs Rail-to-Rail signals. For packing the buffer amplifier, the TAPE AND REEL-axis is adopted. It is recommended that this electronic component be used with an 7.5mA supply. This operational amplifier can conduct a voltage gain of up to 250 at a minimum.
MAX4381EUB+T Features
10 Pins
supply voltage of 5V
Output Type: Rail-to-Rail
MAX4381EUB+T Applications
There are a lot of Maxim Integrated MAX4381EUB+T Instrumentational OP Amps applications.
- Video conversion and routing
- Multiplication circuits
- Fast A/D and D/A converters
- Car stereo
- Home audio systems
- Video computer boards
- RF cable systems
- Signal amplification
- Signal transformation
- Inverse/same-phase proportional circuit
