LT1361CN8#PBF Overview
Packaged in a DIP case, the buffer op amp is ready to use. A total of 8 pins are present on the instrumentation amplifier. There is an input offset voltage of 300μV for this buffer op amp. As long as the supply current of the chip does not exceed 4mA, this op amp ic can operate. 76.12dB should remain the voltage gain. During the manufacturing process, this buffer amplifier is divided into 2 circuits. As far as the device is concerned, buffer amplifier has 2 channels. For the buffer op amp to operate properly, it must be above the temperature of 0°C degrees Celsius. No temperature greater than 70°C should be used. The linear amplifier consists of 2 different elements in total. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 36V. A high supply voltage of more than 5V is recommended for the instrumentation amplifier's supply voltage. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 18V volts. A total of 2 instrumentation amplifiers are present on the device.
LT1361CN8#PBF Features
76.12dB voltage gain
LT1361CN8#PBF Applications
There are a lot of Analog Devices, Inc.
LT1361CN8#PBF Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
