ADG842YKSZ-500RL7 Overview
Shipping overseas is convenient due to the electrical component's packing in 6-TSSOP, SC-88, SOT-363. In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. The multiplexer is located in Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. Increasing operating temperature to around -40°C~125°C TA. Totally, there are 6 terminations. High-quality output is provided by the electronic component's 1 channels. In the case of a voltage supply of 2.5V volts, the electrical part can be powered up and run. It is injected into the electrical part body with 6 pins. Circuits based on SPST - NC switching are used to construct these analog switch ics. Try searching with ADG842 if you're looking for variants. A 370mOhm internal resistance characterizes this multiplexer. To find out what the functions of 6 pins are, please refer to their datasheets. The analogue multiplexer in this example is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 3.6V. A cost-effective Single supply type analogue multiplexer. It is recommended that the electrical component receives a voltage of 1.65V. A voltage of 1.65V~3.6V is required to drain this analog switch from a single voltage supply. Put voltage above 4μA on the multiplexer to cause damage. This electrical part is compatible with 3.6V operating voltages. A 21MHz-bandwidth can be used for data transfer.
ADG842YKSZ-500RL7 Features
1 Channels
Switch Circuit: SPST - NC
Bandwidth: 21MHz
ADG842YKSZ-500RL7 Applications
There are a lot of Analog Devices Inc. ADG842YKSZ-500RL7 Analog Switches & Multiplexers ICs applications.
- Residential Gateways, Home Gateway/Router
- Private Branch Exchange (PBX)
- Automotive applications
- Routers
- Audio and video switching
- Fault Tolerant Systems
- Audio and video signal routing
- RGB switches
- Cable Modem
- Imaging
