ADG836YRMZ-REEL7 Overview
As the electronic part is packed in 10-TFSOP, 10-MSOP (0.118, 3.00mm Width), international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. 2:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature extended to -40°C~125°C TA. Total terminations are 10. The electronic part provides high-quality output because it has 2 channels. Powered by a 1.8V voltage supply, the electrical part should be switched on and run. The electrical component body receives 10 pins. Circuits based on SPDT switching are used to construct these analog switch ics. Try searching with ADG836 to find analog multiplexer variants. An switch multiplexer with 650mOhm internal resistance has a value of 650mOhm. Datasheets for 10 pin functions are available upon request. The analogue multiplexer in this example is a typical Multiplexer or Switches. Multiplexers should not be powered above 3.6V in normal situations. The analog switch ic is of the Single supply type and is cost-effective. The lowest voltage the electronic part should receive is 1.65V. An operating current of 3nA would be sufficient for this switch device. Using a single voltage supply, this switch device consumes 1.65V~3.6V volts. When the digital multiplexer is charged above 1μA, damage can occur. There are 57MHz bandwidths for data transfer. A analog switch ics with 4 outputs is included.
ADG836YRMZ-REEL7 Features
2 Channels
Switch Circuit: SPDT
3nA Supply Current
Bandwidth: 57MHz
ADG836YRMZ-REEL7 Applications
There are a lot of Analog Devices Inc.
ADG836YRMZ-REEL7 Analog Switches & Multiplexers ICs applications.
- Imaging
- Ultrasound
- Audio and video switching
- Automatic test equipment
- Precision data acquisition
- Battery-powered systems
- Sample-and-hold systems
- Communication systems
- Data Acquisition Systems
- Relay Replacement
