ADG802BRT-REEL7 Overview
The electrical component comes in SOT-23-6 packaging, which makes it convenient to ship overseas. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). Surface Mount is where this multiplexer is located. 1:1 is the ratio of multiplexer to demultiplexer circuits. Around -40°C~125°C TA is the extended operating temperature. In total, there are 6 terminations. A high-quality output is provided by the electrical component's 1 channels. When a voltage supply of 3V is used, the electronic component should be turned on and run. There are 6 pins injected into the electronic part body. Multiplexers built on a SPST - NC switching circuit are built. Try searching with ADG802 to find analog multiplexer variants. It has an internal resistance of 300mOhm. Datasheets for functions of 6 pins are available. Multiplexer or Switches is a typical switch device. In normalcircumstances, users should not exceed 5.5V volts for the multiplexer. A low voltage of 1.8V should be applied to the electronic component. The voltage required by this switch device is 1.8V~5.5V, draining from a single voltage supply.
ADG802BRT-REEL7 Features
1 Channels
Switch Circuit: SPST - NC
-3db Bandwidth: 12MHz
ADG802BRT-REEL7 Applications
There are a lot of Analog Devices Inc. ADG802BRT-REEL7 Analog Switches & Multiplexers ICs applications.
- Cross Connects
- Automatic test equipment
- SONET
- Cable Modem
- Mechanical reed relay replacement
- Transmit
- Access Concentrators
- RGB switches
- DVD-R
- Cell phones
