ADG741BKSZ5-REEL7 Overview
Presented in 5-TSSOP, SC-70-5, SOT-353, this electrical component is convenient for overseas shipping. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. In Surface Mount, this analog switch is mounted. Multiplexers and demultiplexers have the same number of circuits 1:1. Operating temperature extended to -40°C~85°C TA. 5 terminations have been made so far. A electrical component with 1 channels is capable of high-quality output. With a 3V voltage supply, the electrical component should be turned on and run. As part of the design of the 5 series, this electronic part has been incorporated into the system. A SPST - NO switching circuit is used to build these analog multiplexers. Try searching with ADG741 if you're looking for variants. The internal resistance of this digital multiplexer is 3Ohm. The functions of 5 pins can be found in the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. Users shouldn't supply more than 5.5V voltage to the switch device. A low voltage of 1.8V should be applied to the electronic component. Analogue multiplexers require a 1.8V~5.5V voltage to drain from a single voltage supply. If you put voltage higher than 1μA on the digital multiplexer, damage may occur. 200MHz bandwidths enable data to be transferred. Resistivity from Drain to Source is 4Ohm for this electronic part.
ADG741BKSZ5-REEL7 Features
1 Channels
Switch Circuit: SPST - NO
Bandwidth: 200MHz
Drain-to-Source resistance: 4Ohm
ADG741BKSZ5-REEL7 Applications
There are a lot of Analog Devices Inc. ADG741BKSZ5-REEL7 Analog Switches & Multiplexers ICs applications.
- Video switching
- Power routing
- Public switching systems
- PDH Multiplexers
- Multiplexers
- Routers
- Data Acquisition Systems
- Audio and video routing
- Signal routing between systems
- Digital Cross-Connects
