ADG715BRUZ-REEL7 Overview
As the electronic part is packed in 24-TSSOP (0.173, 4.40mm Width), international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. 1:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature extended to -40°C~85°C TA. Total terminations are 24. The electronic part provides high-quality output because it has 8 channels. Powered by a 2.5V voltage supply, the electrical part should be switched on and run. The electrical component body receives 24 pins. Circuits based on SPST - NO switching are used to construct these analog switch ics. Try searching with ADG715 to find analog multiplexer variants. An switch multiplexer with 4.5Ohm internal resistance has a value of 4.5Ohm. Datasheets for 24 pin functions are available upon request. Multiplexers should not be powered above 5.5V in normal situations. The analog switch ic is of the Dual, Single supply type and is cost-effective. The lowest voltage the electronic part should receive is 2.7V. An operating current of 10μA would be sufficient for this switch device. When the digital multiplexer is charged above 20μA, damage can occur. Despite this switch device's dual supply capability, its voltage should not exceed 2.75V. It is recommended that you attach at least 2.25V to your dual power supply. There are 155MHz bandwidths for data transfer.
ADG715BRUZ-REEL7 Features
8 Channels
Switch Circuit: SPST - NO
10μA Supply Current
Bandwidth: 155MHz
ADG715BRUZ-REEL7 Applications
There are a lot of Analog Devices Inc.
ADG715BRUZ-REEL7 Analog Switches & Multiplexers ICs applications.
- Imaging
- Ultrasound
- Audio and video switching
- Automatic test equipment
- Precision data acquisition
- Battery-powered systems
- Sample-and-hold systems
- Communication systems
- Data Acquisition Systems
- Relay Replacement
