ADG5434BCPZ-REEL7 Overview
The electronic component is convenient to ship overseas because it is packed in a 20-WFQFN Exposed Pad, CSP. This packaging method provides high reliability because it uses advanced packaging techniques. In Surface Mount, you'll find this switch device. 2:1 is the ratio between multiplexers and demultiplexers. Increasing operating temperature to around -40°C~125°C TA. In total, there have been 20 terminations. A total of 20 pins are injected into the body of the electronic part. Circuits based on SPDT switching are used to construct these analog switch ics. The multiplexer consists of 4 circuits. Try searching with ADG5434 to find analog multiplexer variants. This digital multiplexer has 14Ohm internal resistance. Datasheets for 20 pin functions are available upon request. Multiplexer or Switches is a typical switch device. It is normally recommended that users do not supply the multiplexer with voltages higher than 40V. The analog switch ic is of the Dual, Single supply type and is cost-effective. A low voltage of 9V should be applied to the electronic component. If put voltage greater than 55μA on the device, damage may be caused to the analogue multiplexer. For this switch, a dual supply voltage is feasible, but it must not exceed 22VThe voltage should be at least 9V if you are using dual power supplies. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. There are various bandwidths available for data transfer. Resistivity from Drain to Source is 16Ohm for this electronic part.
ADG5434BCPZ-REEL7 Features
Switch Circuit: SPDT
Bandwidth: 140MHz
Drain-to-Source resistance: 16Ohm
ADG5434BCPZ-REEL7 Applications
There are a lot of Analog Devices Inc. ADG5434BCPZ-REEL7 Analog Switches & Multiplexers ICs applications.
- SONET/SDH ADM
- ISDN NT1/TA
- SDH
- Sample-and-hold systems
- Precision test equipment
- Signal routing between systems
- FTTH
- Precision instrumentation
- Digital Cross-Connects
- Intelligent PBX
