ADG5412FBRUZ-RL7 Overview
As the electronic part is packed in 16-TSSOP (0.173, 4.40mm Width), international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. 1:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature extended to -40°C~125°C TA. Total terminations are 16. The electronic part provides high-quality output because it has 1 channels. Powered by a 15V voltage supply, the electrical part should be switched on and run. The electrical component body receives 16 pins. Circuits based on SPST - NO switching are used to construct these analog switch ics. There are 4 circuits in this switch device. Try searching with ADG5412 to find analog multiplexer variants. An switch multiplexer with 11.5Ohm internal resistance has a value of 11.5Ohm. Datasheets for 16 pin functions are available upon request. Multiplexers should not be powered above 44V in normal situations. The analog switch ic is of the Dual, Single supply type and is cost-effective. The lowest voltage the electronic part should receive is 8V. When the digital multiplexer is charged above 1.2mA, damage can occur. Despite this switch device's dual supply capability, its voltage should not exceed 22V. It is recommended that you attach at least 5V to your dual power supply. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. There are 160MHz bandwidths for data transfer.
ADG5412FBRUZ-RL7 Features
1 Channels
Switch Circuit: SPST - NO
-3db Bandwidth: 270MHz
Bandwidth: 160MHz
ADG5412FBRUZ-RL7 Applications
There are a lot of Analog Devices Inc.
ADG5412FBRUZ-RL7 Analog Switches & Multiplexers ICs applications.
- Imaging
- Ultrasound
- Audio and video switching
- Automatic test equipment
- Precision data acquisition
- Battery-powered systems
- Sample-and-hold systems
- Communication systems
- Data Acquisition Systems
- Relay Replacement
