ADG1422BRMZ Overview
Shipping overseas is convenient with the electronic component packed in 10-TFSOP, 10-MSOP (0.118, 3.00mm Width). This high-reliability packaging method uses advanced packaging methods Tube. Surface Mount is where this multiplexer is located. 1:1 is the number of circuits in the multiplexer and demultiplexer. The operating temperature is extended to around -40°C~125°C TA. Totally, there are 10 terminations. A 1 channel electronic part produces high-quality output. When the electronic component is given a voltage of 5V, it should be turned on and run. An electrical component like this is included in the 10 series. Circuits based on SPST - NC switching are used to construct these analog switch ics. Try searching for ADG1422 variants of the analog switch ic. As far as internal resistance is concerned, it has 2.4Ohm. The datasheets for the 10 pins explain the functions. Multiplexer or Switches is a typical switch device. It is generally not recommended to supply a voltage higher than 16.5V to the switch device in normal circumstances. The analog switch ic is of the Dual, Single supply type and is cost-effective. In order for the electronic part to function properly, the lowest voltage should be 5V. Put voltage above 190μA on the multiplexer to cause damage. For this switch, a dual supply voltage is feasible, but it must not exceed 16.5VIf you are using dual power supplies, you should attach at least 4.5V. Operating voltages range from 12V. Operating 2 inputs is required. This switch operates within the bandwidth of 180MHz.
ADG1422BRMZ Features
1 Channels
Switch Circuit: SPST - NC
Bandwidth: 180MHz
ADG1422BRMZ Applications
There are a lot of Analog Devices Inc. ADG1422BRMZ Analog Switches & Multiplexers ICs applications.
- Switching Systems
- Battery-powered systems
- PBXs
- Relay replacements
- PBX interfaces
- Modems
- New designs requiring multiplexer functions
- Mechanical reed relay replacement
- Frame Relay Equipment
- T1/E1 Terminals
