ADG1222BRMZ-REEL7 Overview
The electronic part can be shipped overseas conveniently because it is packaged in 10-TFSOP, 10-MSOP (0.118, 3.00mm Width). High reliability is achieved by using advanced packaging method Tape & Reel (TR). There is an analog multiplexer mounted in position Surface Mount. Multiplexers and demultiplexers have a ratio of 1:1. An extended operating temperature of -40°C~125°C TA degrees Celsius. In total, 10 terminations have occurred. High-quality output is provided by the electronic component's 1 channels. With a 15V voltage supply, the electrical component should be turned on and run. It is part of the design of the 10 series that this electronic component is included. These analog multiplexers are built based on SPST - NC switching circuits. The multiplexer consists of 2 circuits. Try searching with ADG1222 to find analog multiplexer variants. Internally, this switch multiplexer has a resistance of 200Ohm. Datasheets for functions of 10 pins are available. It is a typical Multiplexer or Switches analog multiplexer. Users should never supply a voltage higher than 16.5V to a switch device. The digital multiplexer has a low cost Dual, Single supply. The lowest voltage fed to the electronic component should be 5V. 140μA current would be enough for this multiplexer to operate. If put voltage greater than 190μA on the device, damage may be caused to the analogue multiplexer. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 16.5V. It is recommended that you attach at least 5V to your dual power supply. This analog switch ic utilizes SEPARATE OUTPUT output. The electronic component can function from 12V. There are 960MHz bandwidths for data transfer.
ADG1222BRMZ-REEL7 Features
1 Channels
Switch Circuit: SPST - NC
140μA Supply Current
Bandwidth: 960MHz
ADG1222BRMZ-REEL7 Applications
There are a lot of Analog Devices Inc. ADG1222BRMZ-REEL7 Analog Switches & Multiplexers ICs applications.
- Industrial and process control systems
- Cable Modem
- Industrial control systems
- Communication systems
- PBX interfaces
- Isolation
- E1 Multiplexer
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- ISDN NT1/TA
- Intelligent PBX
