Name: DG390BDJ
Brand: Vishay Siliconix
SKU: DG390BDJ
Availability: InStock

new-10%

DG390BDJ

Manufacturer part number:DG390BDJ

Manufacturer:Vishay Siliconix

Description:150ns, 130ns (Typ) SPDT 50Ohm Analog Switches 16 Pins 5nA 16-DIP (0.300, 7.62mm)

Case Package:SOT-23

Datasheet:DG390BDJ Datasheet PDF

RoHs Status:non-compliant

Parameter Name	Value
Type	Parameter
Factory Lead Time	8 Weeks
Mounting Type	Through Hole
Package / Case	16-DIP (0.300, 7.62mm)
Number of Pins	16
Operating Temperature	-40°C~85°C TA
Packaging	Tube
Published	2005
Pbfree Code	no
Part Status	Obsolete
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Resistance	50Ohm
Max Power Dissipation	470mW
Reach Compliance Code	unknown
Pin Count	16
Operating Supply Voltage	15V
Number of Circuits	2
Max Supply Voltage	36V
Min Supply Voltage	13V
Nominal Supply Current	230μA
Max Supply Current	1mA
Turn On Delay Time	150 ns
Supply Type	Dual, Single
Turn-Off Delay Time	130 ns
Max Dual Supply Voltage	22V
On-State Resistance (Max)	50Ohm
Min Dual Supply Voltage	7V
Dual Supply Voltage	15V
Multiplexer/Demultiplexer Circuit	2:1
Current - Leakage (IS(off)) (Max)	5nA
Channel Capacitance (CS(off), CD(off))	14pF 14pF
Switch Circuit	SPDT
Switch Time (Ton, Toff) (Max)	150ns, 130ns (Typ)
Charge Injection	10pC
Crosstalk	-74dB @ 500kHz
Drain to Source Resistance	50Ohm
Voltage - Supply, Dual (V±)	±15V
RoHS Status	Non-RoHS Compliant

DG390BDJ Product Details

DG390BDJ Overview

Presented in 16-DIP (0.300, 7.62mm), this electrical component is convenient for overseas shipping. The advanced packaging method Tube provides high reliability. A switch device like this is mounted in Through Hole. Multiplexer and demultiplexer circuits have a number 2:1. Extended operating temperature around -40°C~85°C TA. This electrical component is included in the 16 series of products. The analog switch ics are built using SPDT switching circuits. Circuits number 2 make up this analogue multiplexer. As far as internal resistance is concerned, it has 50Ohm. For details about the functions of 16 pins, please refer to the datasheets. In normalcircumstances, users should not exceed 36V volts for the multiplexer. Analog switch ics with Dual, Single supply type are cost-effective. There should be 13V voltage fed to the electrical part below 13V. A voltage higher than 1mA may cause damage to the switch multiplexer. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 22V. For dual power supplies, a voltage of at least 7V should be attached. Operating voltages range from 15V. Resistivity from Drain to Source is 50Ohm for this electronic part.