DG201BDK Overview
The electronic component is convenient to ship overseas because it is packed in a 16-CDIP (0.300, 7.62mm). The advanced packaging method Tube provides high reliability. Through Hole is where this multiplexer is located. 1:1 is the ratio between multiplexers and demultiplexers. Operating temperature around -40°C~85°C TA extended. The total number of terminations is 16. With a 15V voltage supply, the electrical component should be turned on and run. A total of 16 pins are injected into the electrical part body. On the other hand, analog switches can be constructed using SPST - NC switching circuits. In this multiplexer, the internal resistance is 85Ohm. The functions of 16 pins can be found in the datasheets. There is Multiplexer or Switches analog multiplexer like this in the world. normally, users should not supply switches with voltages higher than 25V. 4.5V is the lowest voltage that should be fed to the electronic electronic part. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 22V. A dual power supply should have at least 4.5V voltage attached. As far as the outputs go, this switch multiplexer utilizes SEPARATE OUTPUT of them. There are 4 inputs to be operated. There is 100mOhm Drain to Source resistance on this electronic part.
DG201BDK Features
Switch Circuit: SPST - NC
Drain-to-Source resistance: 100mOhm
DG201BDK Applications
There are a lot of Vishay Siliconix DG201BDK Analog Switches & Multiplexers ICs applications.
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- RGB switches
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- Mechanical reed relay replacement
- E1 Multiplexer
- 65 V DACs
- Industrial control systems
- Video signal routing
- Precision instrumentation
- DVD-R
