DG1411EQ-T1-GE3 Overview
Packed in 16-TSSOP (0.173, 4.40mm Width), the electronic component is convenient for shipping overseas. The advanced packaging method Tape & Reel (TR) provides high reliability. Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have the same number of circuits 1:1. Increasing operating temperature to around -40°C~125°C TA. Total terminations are 16. A 1 channel electronic part produces high-quality output. When a voltage supply of 5V is used, the electronic component should be turned on and run. These analog multiplexers are built based on SPST - NC switching circuits. There are 4 circuits in this multiplexer. Look for analog switch ic variants by searching with DG1411. Analog switches have 1.8Ohm internal resistance. The datasheets for the 16 pins explain the functions. normally, users should not supply switches with voltages higher than 24V. Analogue multiplexer with a Dual, Single supply type that is cost-effective. The lowest voltage fed to the electronic component should be 4.5V. It may damage the digital multiplexer if the voltage is higher than 1μA. There is no problem with using dual supply voltage, but it should not exceed 15V. When using dual power supplies, you should attach at least 4.5V.
DG1411EQ-T1-GE3 Features
1 Channels
Switch Circuit: SPST - NC
-3db Bandwidth: 210MHz
DG1411EQ-T1-GE3 Applications
There are a lot of Vishay Siliconix DG1411EQ-T1-GE3 Analog Switches & Multiplexers ICs applications.
- Voice over IP/DSL – Integrated Access Devices, Smart
- Isolation
- Communications systems
- Remote wireless modules
- 65 V DACs
- PCMCIA cards
- New designs requiring multiplexer functions
- PBX interfaces
- SONET/SDH ADM
- DSUs
