V62/12614-01XE Overview
In order to protect the op amps, a SOIC case is used. There are two types of operational amplifiers in this circuit. In the case of Tape and Reel cases, linear amplifier will be delivered. In recent months, the number of terminations has approached 8. It consists of a total of 8 pins in total. It would be helpful if you could remember that this op amp ic should be powered by an 15V battery. A type of Operational Amplifier buffer op amp is what this device is specifically, to be more precise. It has 8 pins that make up the linear amplifier. In terms of input offset voltage, operational amplifier rates 3.5mV. Maintain 0dB as the voltage gain. Buffer op amp is equipped with 1 channels on the device. It is recommended that the temperature of this op amp ic should not fall below -55°C degrees Fahrenheit at any time. Linear amplifier shouldn't be used above 125°C degrees. The operating supply voltage of the buffer op amp is rated at 18V. As a result of this, the buffer amplifier is packed in TR. When it comes to the voltage from which this electrical part will operate, it can operate at a maximum of less than 36V. It is recommended that you keep the instrumentation amplifier's supply voltage higher than 4V when using it. It is recommended that you conduct this electronic part using the dual supply voltage of 18V. There is an 810μA quiescent current in linear amplifier. It is important to keep the resistance within the 800kOhm range of the op amps.
V62/12614-01XE Features
8 Pins
supply voltage of 15V
0dB voltage gain
Resistance of 800kOhm
V62/12614-01XE Applications
There are a lot of Texas Instruments
V62/12614-01XE Instrumentational OP Amps applications.
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
