TSM104WAIDG4 Overview
Packaged in a D case, the buffer op amp is ready to use. An op amp ic of the OPERATIONAL AMPLIFIER type. There is a growing number of terminations approaching the number of 16. The pins on this board total to 16 in total. I would like to remind you that this buffer op amp should be powered by an 5V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 16 pins are present on the instrumentation amplifier. There is an input offset voltage of 500μV for this buffer op amp. As long as the supply current of the chip does not exceed 1.4mA, this op amp ic can operate. 100dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 4 channels. For the buffer op amp to operate properly, it must be above the temperature of -40°C degrees Celsius. No temperature greater than 105°C should be used. For packing the buffer amplifier, the TUBE-axis is adopted. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 30V. A high supply voltage of more than 3V is recommended for the instrumentation amplifier's supply voltage.
TSM104WAIDG4 Features
16 Pins
supply voltage of 5V
100dB voltage gain
TSM104WAIDG4 Applications
There are a lot of Texas Instruments
TSM104WAIDG4 Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
