TS5A1066YZPR Overview
Presented in 5-XFBGA, DSBGA, this electrical component is convenient for overseas shipping. In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. It is mounted in the position Surface Mount. 1:1 is the ratio between multiplexers and demultiplexers. Temperatures around -40°C~85°C TA are extended for operation. In total, 5 terminations have occurred. Due to its 1 channels, the electrical component produces high-quality output. It is safe to turn on and run the electronic component with a 1.8V voltage supply. It is injected into the electrical part body with 5 pins. On the other hand, analog switches can be constructed using SPST - NO switching circuits. Try searching for the analog switch ic with TS5A1066 if you are looking for variants. Internally, this switch multiplexer has a resistance of 10Ohm. For details about the functions of 5 pins, please refer to the datasheets. It is a typical Multiplexer or Switches analog multiplexer. It is normally recommended that users do not supply the multiplexer with voltages higher than 5.5V. Single supply type digital switch with a low cost. It is recommended that the electrical component receives a voltage of 1.65V. The switch device would be able to operate with 50nA current. This analogue multiplexer requires a voltage of 1.65V~5.5V when it drains from a single voltage supply. A digital multiplexer may suffer damage if voltage is applied above 1μA. It is possible to transfer data over a 400MHz-bandwidth.
TS5A1066YZPR Features
1 Channels
Switch Circuit: SPST - NO
50nA Supply Current
Bandwidth: 400MHz
TS5A1066YZPR Applications
There are a lot of Texas Instruments TS5A1066YZPR Analog Switches & Multiplexers ICs applications.
- Cable Modem
- Signal routing between systems
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Sample-and-hold systems
- USB 1.1 signal switching circuits
- Microprocessor Controlled Analog Systems
- Digital Cross-Connects
- PBX interfaces
- Access Concentrators
- PBXs
