TS12A4514P Overview
The electronic part can be shipped overseas conveniently because it is packaged in 8-DIP (0.300, 7.62mm). In order to provide high reliability, an advanced packaging method Tube is used. There is an analog multiplexer mounted in position Through Hole. There is 1:1 ratio between the number of multiplexers and demultiplexers. Around -40°C~85°C TA is the extended operating temperature. In total, there are 8 terminations. This electronic part offers high-quality output due to its 1 channels. In the case of a voltage supply of 3.3V volts, the electrical part can be powered up and run. There are 8 pins injected into the electronic part body. The analog switch ics are built using SPST - NO switching circuits. Search with TS12A4514 if you are looking for analog multiplexer variants. It has an internal resistance of 15Ohm. The functions of 8 pins can be found in the datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. In normalcircumstances, users should not exceed 12V volts for the multiplexer. Single supply type digital switch with a low cost. 2V is the lowest voltage that should be fed to the electronic electronic part. In order to operate this switch device, it would need a current of 50nA. A voltage of 2.7V~12V is required to drain this analog switch from a single voltage supply. A digital multiplexer may suffer damage if voltage is applied above 50nA. There are SEPARATE OUTPUT outputs on this analog switch ic. There are 1 inputs to be operated. The transfer of data can be performed over 520MHz bandwidths.
TS12A4514P Features
1 Channels
Switch Circuit: SPST - NO
50nA Supply Current
Bandwidth: 520MHz
TS12A4514P Applications
There are a lot of Texas Instruments
TS12A4514P Analog Switches & Multiplexers ICs applications.
- Isolation
- Medical
- Imaging
- Ultrasound
- Audio and video switching
- Automatic test equipment
- Precision data acquisition
- Battery-powered systems
- Sample-and-hold systems
- Communication systems
