TLV2760IDBVRG4 Overview
A SOT-23-6 case is used to package the op amp. OPERATIONAL AMPLIFIER-type instrumentation amplifiers are used in this application. The case in which buffer amplifier is delivered is called a Tape and Reel case. It is estimated that there will be 6 terminations in the next few months. There are a total of 6 pins on this op amp. It is important to remember that this op amp should be operated at a voltage of 2.4V volts. It should be noted that this op amp is a type of Operational Amplifier device. There are 6 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 3.5mV. An 20μA volt supply current is needed for this linear amplifier to operate. There should be no change in the voltage gain. In order for op amp to function properly, the temperature should not be lower than -40°C degrees Celsius. Instrumentation amplifier should only be used at temperatures up to 85°C. There are a total of 1 elements in this linear amplifier. The operating supply voltage of the buffer op amp is rated at 3V. I would like to point out that this electrical component is capable of working from a voltage below 3.6V as far as the power supply is concerned. As a general rule, it is advisable to keep the op amp's supply voltage above 1.8V at all times. The dual supply voltage of 1.8V should be used for the conduct of this electronic component.
TLV2760IDBVRG4 Features
6 Pins
supply voltage of 2.4V
101.58dB voltage gain
TLV2760IDBVRG4 Applications
There are a lot of Texas Instruments
TLV2760IDBVRG4 Instrumentational OP Amps applications.
- Addition operation circuits
- Subtraction operation circuits
- single/dual op amp sum and difference circuits
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
