TLV2455CNE4 Overview
In the package, you will find a PDIP-case to contain the op amp ic. The instrumentation amplifier in this picture is of the OPERATIONAL AMPLIFIER-type. A Rail/Tube case is used for delivering the op amp. During the past two weeks, there have been close to 16 terminations. A total of 16 pins are located on this board. This linear amplifier should be powered by an 3V battery. This particular linear amplifier is a type of Operational Amplifier device, to be precise. The op amp ic has an array of 16 pins on it. Op amp rates 1.5mV as input offset voltage. Using an 23μA supply current, this operational amplifier ics can be operated. You should keep the voltage gain at 103dB for the time being. To operate this buffer amplifier, the temperature must not be lower than 0°C. A temperature greater than 70°C should not be used for the operation of buffer amplifier. 4 elements make up the design of this buffer amplifier. The operating supply voltage of the buffer op amp is rated at 3V. This electric component can work from a voltage of under 6V as far as supply voltage is concerned. A voltage of 2.7V or higher is recommended for the linear amplifier's supply voltage. This electrical part should be conducted under the dual supply voltage of 3V volts when you conduct this part.
TLV2455CNE4 Features
16 Pins
supply voltage of 3V
103dB voltage gain
TLV2455CNE4 Applications
There are a lot of Texas Instruments
TLV2455CNE4 Instrumentational OP Amps applications.
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
- Signal filtering
- Signal operation
- Video computer boards
