TLV2381IDRG4 Overview
In order to protect the op amps, a D case is used. There are two types of operational amplifiers in this circuit. In the case of Tape and Reel cases, linear amplifier will be delivered. In recent months, the number of terminations has approached 8. It consists of a total of 8 pins in total. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. It has 8 pins that make up the linear amplifier. In terms of input offset voltage, operational amplifier rates 4.5mV. In order for this instrumentation amplifier to operate, the supply current needs to be between 7μA and 10 . Maintain 100dB as the voltage gain. It is recommended that the temperature of this op amp ic should not fall below -40°C degrees Fahrenheit at any time. Linear amplifier shouldn't be used above 125°C degrees. As a whole, there are 1 elements that make up this buffer amplifier. The operating supply voltage of the buffer op amp is rated at 8V. When it comes to the voltage from which this electrical part will operate, it can operate at a maximum of less than 16V. It is recommended that you keep the instrumentation amplifier's supply voltage higher than 2.7V when using it. It is recommended that you conduct this electronic part using the dual supply voltage of 8V.
TLV2381IDRG4 Features
8 Pins
supply voltage of 5V
100dB voltage gain
TLV2381IDRG4 Applications
There are a lot of Texas Instruments
TLV2381IDRG4 Instrumentational OP Amps applications.
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
