TLV2252MJGB Overview
Packaged in a CDIP case, the buffer op amp is ready to use. An op amp ic of the OPERATIONAL AMPLIFIER type. The op amp is delivered to you in a Rail/Tube case. There is a growing number of terminations approaching the number of 8. The pins on this board total to 8 in total. I would like to remind you that this buffer op amp should be powered by an 3V battery. A total of 8 pins are present on the instrumentation amplifier. There is an input offset voltage of 1.5mV for this buffer op amp. 124.61dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 2 channels. For the buffer op amp to operate properly, it must be above the temperature of -55°C degrees Celsius. No temperature greater than 125°C should be used. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 8V. A high supply voltage of more than 2.7V is recommended for the instrumentation amplifier's supply voltage. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 4V volts.
TLV2252MJGB Features
8 Pins
supply voltage of 3V
124.61dB voltage gain
TLV2252MJGB Applications
There are a lot of Texas Instruments
TLV2252MJGB Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
