TLE2081IDR Overview
In order to protect the op amps, a 8-SOIC (0.154, 3.90mm Width) case is used. The instrumentation amplifier in this picture is of the J-FET-type. As far as the packaging is concerned, buffer op amp is delivered in a Tape & Reel (TR) case. During the past two weeks, there have been close to 8 terminations. The pins on this board total to 8 in total. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. A type of Operational Amplifier buffer op amp is what this device is specifically, to be more precise. 8 pins are available on the instrumentation amplifier. With regards to the offset voltage of the input, buffer amplifier is rated at 6mV. This electronic part is recommended for mounting type Surface Mount. In terms of operating temperatures, this buffer amplifier works very well at a temperature of around -40°C~85°C . As long as the supply current of the chip does not exceed 1.7mA, this op amp ic can operate. Keeping the voltage gain at 106dB is the best course of action. 1 elements make up the design of this buffer amplifier. The operating supply voltage of instrumentation amplifier is rated 19V voltage. For the packing of the instrumentation amplifier, TR is adopted. As the name implies, Excalibur? refers to the series of the buffer op amp.
TLE2081IDR Features
8 Pins
supply voltage of 5V
106dB voltage gain
TLE2081IDR Applications
There are a lot of Texas Instruments TLE2081IDR Instrumentational OP Amps applications.
- Differentiator circuits
- E-book readers
- Weighing systems
- Vehicle electronics
- Laptop
- Displayers for aircraft and air transportation control systems
- Inverse/same-phase proportional circuit
- earphone
- Polarized electrodes
- Power control
