TLE2021AIDRG4 Overview
Packaged in a SOIC case, the buffer op amp is ready to use. An op amp ic of the OPERATIONAL AMPLIFIER type. The op amp is delivered to you in a Tape & Reel case. There is a growing number of terminations approaching the number of 8. The pins on this board total to 8 in total. I would like to remind you that this buffer op amp should be powered by an 15V battery. A total of 8 pins are present on the instrumentation amplifier. There is an input offset voltage of 80μV for this buffer op amp. As long as the supply current of the chip does not exceed 240μA, this op amp ic can operate. 123.52dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 1 channels. For the buffer op amp to operate properly, it must be above the temperature of 0°C degrees Celsius. No temperature greater than 70°C should be used. For packing the buffer amplifier, the TAPE AND REEL-axis is adopted. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 40V. A high supply voltage of more than 4V is recommended for the instrumentation amplifier's supply voltage. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 20V volts.
TLE2021AIDRG4 Features
8 Pins
supply voltage of 15V
123.52dB voltage gain
TLE2021AIDRG4 Applications
There are a lot of Texas Instruments
TLE2021AIDRG4 Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
