TLC2264CPWG4 Overview
In the package, you will find a TSSOP-case to contain the op amp ic. The instrumentation amplifier in this picture is of the OPERATIONAL AMPLIFIER-type. A Rail/Tube case is used for delivering the op amp. During the past two weeks, there have been close to 14 terminations. A total of 14 pins are located on this board. This linear amplifier should be powered by an 5V battery. The op amp ic has an array of 14 pins on it. Op amp rates 2.5mV as input offset voltage. Using an 850μA supply current, this operational amplifier ics can be operated. You should keep the voltage gain at 114.81dB for the time being. To operate this buffer amplifier, the temperature must not be lower than 0°C. A temperature greater than 70°C should not be used for the operation of buffer amplifier. 4 elements make up the design of this buffer amplifier. The operating supply voltage of the buffer op amp is rated at 8V. This electric component can work from a voltage of under 16V as far as supply voltage is concerned. A voltage of 4.4V or higher is recommended for the linear amplifier's supply voltage. This electrical part should be conducted under the dual supply voltage of 8V volts when you conduct this part.
TLC2264CPWG4 Features
14 Pins
supply voltage of 5V
114.81dB voltage gain
TLC2264CPWG4 Applications
There are a lot of Texas Instruments
TLC2264CPWG4 Instrumentational OP Amps applications.
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
- Signal filtering
- Signal operation
- Video computer boards
