TLC2252AIPE4 Overview
A PDIP case is used to package the op amp. OPERATIONAL AMPLIFIER-type instrumentation amplifiers are used in this application. The case in which buffer amplifier is delivered is called a Rail/Tube case. It is estimated that there will be 8 terminations in the next few months. There are a total of 8 pins on this op amp. It is important to remember that this op amp should be operated at a voltage of 5V volts. There are 8 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 850μV. An 80μA volt supply current is needed for this linear amplifier to operate. There should be no change in the voltage gain. In order for op amp to function properly, the temperature should not be lower than -40°C degrees Celsius. Instrumentation amplifier should only be used at temperatures up to 125°C. There are a total of 2 elements in this linear amplifier. The operating supply voltage of the buffer op amp is rated at 8V. I would like to point out that this electrical component is capable of working from a voltage below 16V as far as the power supply is concerned. As a general rule, it is advisable to keep the op amp's supply voltage above 4.4V at all times. The dual supply voltage of 8V should be used for the conduct of this electronic component.
TLC2252AIPE4 Features
8 Pins
supply voltage of 5V
124.61dB voltage gain
TLC2252AIPE4 Applications
There are a lot of Texas Instruments
TLC2252AIPE4 Instrumentational OP Amps applications.
- Addition operation circuits
- Subtraction operation circuits
- single/dual op amp sum and difference circuits
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
