TLC1078IPE4 Overview
A PDIP case is used to package the op amp. An op amp of this type is a OPERATIONAL AMPLIFIER-type. In the case of Rail/Tube cases, linear amplifier will be delivered. It is estimated that there will be 8 terminations in the next few months. The total number of pins on linear amplifier is 8. Please take in mind that this instrumentation amplifier should be run at 5V. It should be noted that this type of buffer amplifier is exactly what is known as a Operational Amplifier device. The op amp ic has an array of 8 pins on it. As far as the input offset voltage is concerned, linear amplifier rates at 450μV. In order for this instrumentation amplifier to operate, the supply current needs to be between 29μA and 10 . 114.4dB should be the voltage gain. To operate this buffer amplifier, the temperature must not be lower than -40°C. In order to avoid damage to the product, operational amplifiers should only be used at temperatures below 85°C. Depending on the chip's operating supply voltage, op amp ic has a rated voltage of 2. This electric component can work from a voltage of under 16V as far as supply voltage is concerned. The linear amplifier's supply voltage should be higher than 3V.
TLC1078IPE4 Features
8 Pins
supply voltage of 5V
114.4dB voltage gain
TLC1078IPE4 Applications
There are a lot of Texas Instruments TLC1078IPE4 Instrumentational OP Amps applications.
- High/low-pass filter circuit
- Band-stop filter
- Polarized electrodes
- Large motor controllers
- Signal transformation
- Weak signal detection
- Communication
- Subtraction operation circuits
- Addition operation circuits
- Video amplifiers
