TLC082CPE4 Overview
Packaged in a P case, the buffer op amp is ready to use. There is a growing number of terminations approaching the number of 8. The pins on this board total to 8 in total. I would like to remind you that this buffer op amp should be powered by an 5V battery. A total of 8 pins are present on the instrumentation amplifier. There is an input offset voltage of 390μV for this buffer op amp. As long as the supply current of the chip does not exceed 1.9mA, this op amp ic can operate. 120dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 2 channels. For the buffer op amp to operate properly, it must be above the temperature of 0°C degrees Celsius. No temperature greater than 70°C should be used. The operating supply voltage of the buffer op amp is rated at 8V. For packing the buffer amplifier, the TUBE-axis is adopted. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 16V. A high supply voltage of more than 4.5V is recommended for the instrumentation amplifier's supply voltage. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 8V volts.
TLC082CPE4 Features
8 Pins
supply voltage of 5V
120dB voltage gain
TLC082CPE4 Applications
There are a lot of Texas Instruments
TLC082CPE4 Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
