TLC074CDRG4 Overview
In order to protect the op amps, a SOIC case is used. There are two types of operational amplifiers in this circuit. In the case of Tape and Reel cases, linear amplifier will be delivered. In recent months, the number of terminations has approached 14. It consists of a total of 14 pins in total. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. A type of Operational Amplifier buffer op amp is what this device is specifically, to be more precise. It has 14 pins that make up the linear amplifier. In terms of input offset voltage, operational amplifier rates 1.9mV. In order for this instrumentation amplifier to operate, the supply current needs to be between 2.1mA and 10 . 120dB should remain the voltage gain. It is recommended that the temperature of this op amp ic should not fall below -40°C degrees Fahrenheit at any time. Instrumentation amplifier shouldn't be used above 125°C . For the operating supply voltage of the op amp ic, there is a rating of 4. The operating supply voltage of the buffer op amp is rated at 8V. When it comes to the voltage from which this electrical part will operate, it can operate at a maximum of less than 16V. It is recommended that you keep the instrumentation amplifier's supply voltage higher than 4.5V when using it. It is recommended that you conduct this electronic part using the dual supply voltage of 8V.
TLC074CDRG4 Features
14 Pins
supply voltage of 5V
120dB voltage gain
TLC074CDRG4 Applications
There are a lot of Texas Instruments
TLC074CDRG4 Instrumentational OP Amps applications.
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
